winch help - M715 Zone

March 31st, 2004, 08:24 PM

Nuke_mcinfantry Nuke_mcinfantry is offline

Private

Join Date: Dec 2003

Location: near baton rouge, la

Posts: 181

how do you get the shaft out of the drum? do you need to? my brass gear is not flat across the teeth. its scalloped in the middle. is it supposed to be?

i am re sealing it and cannot figure out how to get the brass gear off. or do i need a ress to just ress bothbrass gear and dog eared side off leaving the center shaft in the drum?

__________________
1967 M-715 (A1)
www.homepage.mac.com/ltalessi

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Show me your winch (BUILT) winch bumpers	bluesman2a	Modified Tech	26	June 21st, 2009 10:45 AM
pto winch	foodstamp	Modified Tech	10	December 31st, 2007 08:27 AM
m37 winch set-up	646dan	Open Discussion	5	December 30th, 2007 06:42 AM

All times are GMT -7. The time now is 08:10 AM.

This site is owned and operated by:
M715 Zone, LLC
President: Jon Schmidt, User ID=brute4c
If you have any suggestions, comments, problems or questions, contact: brute4c@m715zone.com

Use of this site means you understand and agree to our TERMS OF USE

Copyright Notice:
This web site is subject to the protection of the copyright laws of the United States and other countries.
Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce,
publish, license, create derivative works from, transfer, or sell any information obtained from any part of the
M715 Zone website without the prior written permission of M715 Zone, LLC.

Written permission can only be obtained by contacting brute4c@m715zone.com

Copyright 1998-2009