Does anyone have a picture or a good drawing of the brackets that bolt to the muffler? The maintenance manual has the best drawing I've seen, but it leaves a lot to the imagination.
Thanks all!
Does anyone have a picture or a good drawing of the brackets that bolt to the muffler? The maintenance manual has the best drawing I've seen, but it leaves a lot to the imagination.
Thanks all!
1968 M-715 w/1100R16s on Stockton wheels, H3 headlights, 2bbl upgrade...
I can take a few exhaust photos later today.
I don't know if I have an extra bracket that I can make a tracing of, but I will check.
I couldn't make it to the garage today , but here are few photos that I had on a SD card to ponder over until tomorrow. I will get that thickness also.
Front view: I fastened the cable with bolts at the muffler. I still have to make the correct pins. Can't find them for sale. I will have to copy one of the originals that was still on the frame mount.
Can't see "C" bracket in this rear view of muffler rear flange it's on the outer side of pipe toward the frame. But same setup.
Crap! I need to dust the inside of the frame rails.
Yeah! That's kind of what I thought they should be. From that angle, they don't look thick enough to need a 1 3/4" bolt, but I got 'em, sooo... [emoji846]
I think I saw the pins at the local hardware store. 1/4" x 1/2" (maybe?). I have the 2 pins in the crossmember/hanger to compare to if I can't look up dimensions from the NSN. I'll let you know what I end up with.
Dust the frame?! I'd think there was something wrong if I didn't have dirt, mud or rust falling all over me every five minutes. [emoji16]
Maybe some day! [emoji1]
Thanks!
Pins are 5/16 x 3/4 overall.
Sent from my moto x4 using Tapatalk
Last edited by TJinSD; April 28th, 2019 at 10:12 PM. Reason: Update pin size
1968 M-715 w/1100R16s on Stockton wheels, H3 headlights, 2bbl upgrade...
Ohhhhh, slots! I didn't notice that in the first pictures. Yeah, I'll send you my email in a minute. Thanks for all the help. You've saved the day again!
1968 M-715 w/1100R16s on Stockton wheels, H3 headlights, 2bbl upgrade...
Can you post a tracing on the site?
Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |