You should put the motor at tdc on the compression stroke, then see where the rotor is pointing in the ignitor. That is where number 1 is on your unit. Then run your wires counter clockwise on the ignitor from that point in the firing order 1-6-3-5-2-4.
To put the motor at tdc on compression, take out the #1 spark plug and crank a little at a time or turn the motor with a socket on the crank bolt until the timing mark on the dampner is at 0 degrees. if you have the valve cover off, the vales should both be closed on the #1 cylinder. If so, you are at tdc. If you dont take the cover off, then you will need to havesomeone crank the motor while you hold your finger in the #1 spark plug hole. crank a little at a time until the pressure blows your finger from the hole. This will be close to TDC....line up the dampner mark, which should be close at that point, and you will be at tdc.
Lord send your Holy Ghost into our hearts and make the desire of our hearts Your Will.
Pro-choice, that's a LIE, babies don't choose to die!!