Can you post the part numbers for all of the bearings and seals? Did you find a replacement thrust washer for yours? Are there any specialty tools needed?
 |
 |
|
|
Private
Can you post the part numbers for all of the bearings and seals? Did you find a replacement thrust washer for yours? Are there any specialty tools needed?
Sergeant
For the hard to find stuff, our zone member " e8eing " shared this with me.
He bought the hardened thrust washer, and shift shafts from here:
http://www.mseriesrebuild.com/budd.htm
I will have to find, and post the input bearing number.
The others, I used this link for the part #s for the bearings, shims and seals.
http://blog.gieselman.com/post/NP200...e-Rebuild.aspx
I bought all of my bearings and seals "piece meal" off of ebay. I didn't save any money, but, I was able to find and buy NOS bearings made in the USA
You really need to make up a pilot shaft to install the intermediate shaft.
I also turned out a spacer tool used to set the intermediate gear bearings as shown in the manual. Also I made a tool to press the bearings on.
Posting Permissions
| Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
|
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |
 |
Reply With Quote