Parts list link on BRAKES

[YEromvek]

I'm needing the Part Number for my Slave Cylinders for my rear axle. I tryed honing them out, but they still are leaking, so I'm ready for that Swap people say they do with some FORD VAN Cylinder, but on the link that has the parts number isn't working properly. Can someone please write me with the part number and the Brake line Adapter that I will need to buy,.
THANKS

[brute4c]

You can buy some that fit 93-94 Ford 1 tons.
Tru torque W37262 and W37263, left and right.
The following are part numbers for one side, not sure which off hand
Bendix 33595
Raybestos WC37263
EIS EW73615
Wagner F73615

There is NO adapter needed. These will bolt on with a little work with a hand or rotary file. All you need to do is open up the 2 bolt holes in the backing plate on the bottom. The new bolts want to be about ½ a hole lower than the existing holes. I did use a washer under the bolt head due to the hole being longer like that now.

[brute4c]

Also....the left side and the right side are different, the front and the rear on the same side are the same.

[rboltz]

37262 and 37263 $16.59 each.

[randyscycle]

I used the NAPA ones and they fit right up after slightly enlarging the mount holes. No adapter was needed. The line screwed right in just like the original.

[YEromvek]

Thanks everyone I found that you are correct I ordered one at checker on sunday and picked it up today on my way home from work. I LOVE this forum!!