ok, can someone post a pic on how the rear part of the tire carrier attaches to the frame? is there a bolt? or a catch? I do not have a hole in my frame where a bolt would attach? any help would be appreciated
Duane
ok, can someone post a pic on how the rear part of the tire carrier attaches to the frame? is there a bolt? or a catch? I do not have a hole in my frame where a bolt would attach? any help would be appreciated
Duane
On my bumper,below and right of where some idiot used a torch to rid of the pintle hook is a bolt hanging. That is where the tire carrier rests. The other end is the bracket just above and to the left of the pumpkin. Hope this helps...Ken
Thanks for all the help!
Hey Ken, is that you in the pic?
No, but we do have the same barber ; p
This was the 1st time I drove the truck back in November '09. I went around the block to a shop for a complete lubrication. The only changes since then noticable in the pic is a new exhaust system and tires. How do I fix that darn bumper/pintle? Guess I need an artist with a cutting torch and a welder.
Thanks for all the help!
Find a scrap frame with a good rear crossmember and replace yours with donor trucks.
So the carrier runs on an angle to the right side the pintle, I was thinking it ran straight back, I am assuming you need to tighten and loosen the nut to remove the hanger.
I will look for the hole in the frame when I get home.
Thanks
Duane
Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |