Gents,

I am amassing parts to start the build on my M715 and was wanting some input from guys who have swapped drivelines before.

I have a Chevy Duelly Dana 60 front that I got for a smoking deal. This has a 77" WMS to WMS with the duelly hubs. If I put standard SRW Hubs this knocks the WMS down to 69.5".

I also have a 14 bolt SRW rear end that is the standard 67"? width.

I am debating on getting a set of SRW hubs for the Dana 60 front to knock down the width as I am going to completely rebuild the front axle before installing it.

The plan is to use a set of 17" beadlock wheels on this setup and run 40" tires on them. I don't really want to run HMMV wheels due to the limited tire options and the ridiculous offset.

Th main issue is a set of Dana 60 SRW hubs now run upwards of $450, and it would make me nervous to put 5" of spacers on each side of the rear axle.

Any input is appreciated.