Quote Originally Posted by jeepdan View Post
I'm going to correct myself, I intended to say that the "hose fitting" needs to be on the far left.

I used these 10" shop vac nozzles from Lowes.
https://www.lowes.com/pd/Shop-Vac-10...Nozzle/1115361

I cut the right side off, and then welded up the hole left after cutting.
The plastic was easy to weld up using a soldering iron.
I did this too, except nozzles from HD.

I dropped fender washers and longer bolts down through the vent- the stock studs are too short.