The pices to connect the cables to are there...basically lik George Walker said above...people have converted the underdash unit to cable...the underhood box is always cable operated.

If I remember right, the tower that the canle sheath is held on to is there...but the little plat that goes over the cable sheath to actually hold it in place isnt and the hole may not be in the tower for the screw to go in...so...

Get a cable, run it to the post that the cable end goes on to operate that door...line the cable up nice on the tower...make a little plate with a bend to clamp the cable down...put the little plate on the cable and drill through both the plate and tower...might be able to thread the tower hole so it might need to be smaller OR weld a nut on the rear of the tower...my choice...and good to go.

You could take a piece of 3/8ths steel and cut a round groove in it to clamp the cable sheath...otherwise a piece of 1/8ths inch bent in a V on the endwith a flat tai on one side will work fine.