Re: Stripping vs Blasting and other ?'s
Post by vrod02 on Dec 23, 2006, 7:42pm

Aircraft stripper lots!Were a approved resperator. outside 50-60 day cover with thin plastic ,the right stuff that dont melt!Cannot be exposed to air or the stripper will not bite correctly. let sit for 1 1/2 hours powerwash all coats off in 30 minutes to bare metal.Dry!!!!! lightly hase wd40 so not to flash pull inside then if you want to detail up with sanding or blasting go for it.This will save you money if you send it out to bead blast,most here are 90 an hour. so 90% of the blasting is done via stripper.Plus the gay coats are light in the hard to reach areas, comes of quick with the blast if you want to disasemble. Bed removal does'nt look to be hard just soak all bolts including tank strap with break loose for a couple days would be my .02