 |
 |
Private
40grit :
Re: Width of Factory Bumper?
Post by 40grit on Oct 18, 2006, 8:31pm
I had the machinist mill both top and bottom inside the channel so it was parallel( relative to outside the channel), then welded in a flat piece on each side to make both inner sides flat against the frame...
should be way overkilll....
Posting Permissions
| Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
|
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |
 |
