Something is wrong Bill. It looks very loose. I had to pull like heck to make the snaps on mine. The middle bow was a bear to pull snaps down around. The side panels required a serious pull down and around the bow side to make the lowest snap. That made it cover the top cab edge.
It looks like a loose fold above the drivers side between bows. When on my truck it was tight as could be.
The side panels came all the way down on my cab side. It looks to high and not laying right in the picture. When the metal buckles were tight as heck, I still had 1/2 inch of strap I could still pull above the footman loop.
You could bounce a quarter off the top when on my truck. I absolutely hope my truck top parts are not modified by a previous owner or just plain wrong.
It would not surprise me. Dang me.
The one thing you should do is run your fingers across the top of the windshield frame to get the flap to lay back towards the middle bow. I can see it is not all laying back evenly. Same with the back flap. Flip it forward over the bow towards the middle bow.
Is it loose at all? It really looks like it.. Can the side panels be pulled down to cover the cab side? Would you please tell me what is not right. Every single thing!
It looks WAY different from being on my truck. I am not happy with that fit at all. No more tops are getting made till I know this top is perfect. Bill, if we need to make it over I will. Please send me a PM and I want to know why it is laying different.
EDIT:
This is how low the side panels were on my truck. Note the door frame bottom edge with the snap around the corner.
EDIT #2: I am recalling the used canvas top you sent appeared shrunk and it would not fit. My first pictures of that were wrong and later I found it appeared to be shrunk only by 2 plus inches and not 5 in the pictures. This is a clue that maybe my truck is wrong. There has to be an explanation for the difference.
 |
 |
Reply With Quote
