Randy, I'm pulling up your old thread in hopes of getting some advise. I saw your post about melting the solder to pull the pickup tube.
I dont know how far that I need to go, so maybe you have a recommendation or two. I tend to sometime over complicate things, because I want to do it once, and hopefully the correct way
I pulled my tank today, and it doesnt look too bad. Its pretty shiny inside for the most part. Would you recommend an Ospho rinse anyway, will Ospho mix with the residual gas or do I need to hose it out. I"m not keen on that because I'm not sure where to dispose of the gas/water mix.
I can see the sock in the tank to well, but it doesnt look terrible. I do have a coil of 3/8 galvanized fuel line and a flaring tool, and could possibly do your mod.
I have the tank out, and mostly empty - what would you do? (WWRD) ha!
Thanks, George
Joshua 24:15