These pictures are for members who asked how I did mine with 1/4 by 3" plate steel. The reason was the factory steel is well kinda thin for rockers. I bought one replacement rocker from Jeeppanels plus, and decided after looking at it to build by own so I don't have to run any kind of nerf bars are side bars or steps. Any ways hope the pictures come out.















I hope that helps, I kept the factory bends front and rear of the cab, and welded in the plate. The bottom plat goes over to the cab supports and if fully welded. It ended up giving me about a half inch more rocker clearance. If I tag anything with the rockers I'll probably bust a cab mount. Hope these help, good luck. Fisherman