Good reading this morning... Lots of progress so far. And good idea printing the mounts for a fit check. I need to get a 3D printer. Your floors... wow they look great. So rare to find them without lots of pitting or just plain full of holes. I just pulled my truck into the shop yesterday evening. I have a painless wire harness for it. That and I need to build a few wire components to graft into it. I have a drivers door gap issue too. Not enough gap on the handle end. It's going to chip my new paint..LOL I don't have a lot of room in there but hope to fix that with unpacking and organizing. I just moved. Keep posting despite the slow nature of this site. I know some long time members read but don't always post much. This site is a very good resource. And the false shine of fakebook will pass and this site again will breathe like it used to. I am holding out for that. Great truck and like the mods.
Liz, covid, murdered 10/19/21