Request for a little help

[fmbruce]

Hi. I have recently bought a M715 in England. Could somebody do me a kindness and measure the distance between the bed floor and the bottom of the top bow in the center? I have a non-original rear canvas assembly and I want to put the correct canvas cover on the vehicle, but my bows are too high. Many thanks in advance, Bruce Hoad

[Barrman]

Welcome to the Zone. My truck doesn’t have stock bows either so I can’t help with this question. Someone will chime in with an answer though. I know there have been several threads in the past that show this dimension as well.

[Kaiserjeeps]

Yes welcome to the zone. What barrman is saying is try a good search. There is quite a bit of information on this site. Sometimes you have to dig a little bit. But I am sure between the manuals or stickeys, and or searching, someone will chime in with a stock truck and help. There are some stunning trucks here. Again, welcome! And post up your truck when you can. All of us are interested in the remaining trucks no matter where they are and having a look.

[jeepdan]

Welcome to the Zone

I will push my truck away from the garage wall tomorrow, so that I can climb up inside of the bed and take a measurement for you.
M715 rear bumpers are touching the back wall in order to keep my Gladiator parked indoors.

It's a tight fit in there.

[jeepdan]

From the surface of the bed floor between the ridges, it is 56 1/4" to the top surface of the wooden bow at center beside the metal tube.