M715 Fire Truck

[onemanarmy]

So I have a 360/4 speed/tcase out of a 1974 J truck that will be swapped in

What motor mounts do I need to get? I'm fine with modifying a bit, but would like to start with something close.

Thanks!

[onemanarmy]

so I'm installing a J truck engine/trans/tcase as 1 unit

not using the stock divorced T case

will I have driveshaft length problems?

[gonz]

What transmission/tcase are you going to use? That will help people who did the same swap let you know what they did for drive line adjustments.

[onemanarmy]

360 / T18/ D20

I have both the J truck and the M715 driveshafts

was hoping the rear driveshaft wouldn't be too long

thanks

[onemanarmy]

changing gears....

gonna swap in a 2002 5.3 LS and a 4l60 and keep the NP200

does anyone have an example of what they did for Tcase lever brackets with an engine/trans swap?

thanks

[onemanarmy]

In the course of this engine swap, I'm upgrading to a pedal mounted brake light switch.

I want to remove the pressure switch.

Anyone know the threads for a plug where the pressure light switch goes?

Thanks

[Flingarrows]

I thought it might be 1/4?, but not 100% sure.

I went with a pedal mount as well. I think that I browsed Napa until I found what I was looking for.

[onemanarmy]

thanks. I'll start with that plug size and go from there.

any pics of your pedal mounted setup?

[Flingarrows]

I will give it a look. It might be easier to snap a picture. Heading out for business for a few day, but will try to get it on the weekend.