Stock Exhaust Photo Reference

[jeepdan]

I have taken a few photos of my stock exhaust to help out future Zoners.
I wish that I would have had this as a reference, it would have saved a lot of time and frustration.
If anyone has any corrections, please comment.

Here is the tailpipe hanger. The rubber insulator is from VPW, and the clamp is something that I made by hand from looking at the parts illustration.

[jeepdan]

A few more of the various locations.

[jeepdan]

Can't leave out a shot of the engine

[brute4c]

Holy cow...that is absolutely beautiful and so very nice of you to post!!!

[JimmieM725]

Dang, Shiney DriveShaft too. I followed your Build its Beautiful.... But Most of All-- THANKS FOR THE KNOWLDGE!!!!! Its been very helpful.

[jeepdan]

Thanks

I just realized that I didn't show any of the cable hangers at the muffler.
I will post them tomorrow.

[bmac6026]

You have the truck that I have to see in person ! very nice!

[David Zelinski]

I like your hanger set up! I'll post a pix of what we came up with for mine. and also- I have so far to go to have my truck looking like yours!

[Von]

Wow... Gorgeous! The red backing plates are a nice touch.

My truck is lucky I hit it with a power washer while I had the engine out... and it's not a very powerful washer.

And knowledge! The hanger bolted to the transmission mount. When I pulled that off on mine I didn't know if that was stock or another goofy field mod...

[jeepdan]

Wow... Gorgeous! The red backing plates are a nice touch.

My truck is lucky I hit it with a power washer while I had the engine out... and it's not a very powerful washer.

And knowledge! The hanger bolted to the transmission mount. When I pulled that off on mine I didn't know if that was stock or another goofy field mod...

Thanks
Von,
The backing plates were left red oxide primer as they came from the factory.
My camera makes them appear more red than they actually are.