Need replacement gears for T98

[Tobcotton]

I'm trying to find somewhere that has gears for the T98. Having no luck. I think it is the (Hub, Clutch, Low and Second gear) "image #23" on the transmission main shaft and the (Gear, Reverse Idler gear) "image #10" on the reverse idler shaft. Is there anywhere to find new replacements?
Thanks

[rboltz]

AB Linn has different T98 shafts and gears listed on e-bay from time to time but I don't know which ones. Give him a call.

[gotzskillz]

If you end up striking out, I've got a spare t98 that I'm selling. Just missing the shift lever. Located in Raleigh, NC so not too far away.

[fisherman]

I have two used t-98 torn down. I would be willing to sell what you need. They both worked before I tore into them.

[Tobcotton]

These are the two gears I need.
Hub, Clutch, Low and Second gear

and the gear below it is

Gear, Reverse Idler gear

[md1970]

Common problem as most dont know how to drive a non syncro 1st & reverse trans and this is the result. 2nd 3rd gears are syncronized and if you put the trans in say 2nd "before" you go to 1st or reverse this will not happen. it slips right in with no grinding at all.

[md1970]

plus you have to be at a dead stop to go into 1st or reverse with the t98.

[jeepdan]

These are the two gears I need.
Hub, Clutch, Low and Second gear

and the gear below it is

Gear, Reverse Idler gear

Help!
I just removed the top of my transmission to check things inside.
Everything shows little, if any wear (17,000 miles).
But my sliding low gear and it's mating gear (reverse idler gear) are chipped very badly from improper shifting.
I don't know how bad is too bad.
I'm using Tobcotton's picture as an example, as the damage looks about the same.
I need help finding good usable gears to replace them.

I'm willing to pay well for very good or NOS gears.
I have come to far to "cheap out" on the transmission.