FedEx Track # puts his parts here Thursday
High Angle Drive's NP205 1410 yokes on the way from CA, as we speak.
Velvet needs:
5/8" round stock made into eight U-Bolts to hold the axles in.
Wheel studs put into hubs then hub rotor assy slapped on the front spindles.
6 more studs put in the rear hubs.
D60 pulled out.
Plate perches made for spring over.
Rockwell front axle installed.
Steering arm for top of knuckle...built.
*steering assist if time allows...which isn't looking good.*
front brakes hard lines.
rear brake hard lines.
The rubber lines from frame to axle.
Axle breathers.
Profuse bleeding...hopefully JUST of brakes.
Driveshafts retubed.
E-Brake relocated from yoke change.
Then...I gotta hope that the truck sits about level with the shackle reversal in the rear and the spring over in the front.
 |
 |
