Wiring Diagram
Post by barrman on Aug 14, 2006, 3:17pm
Since I have been on a paint spree the last few months, I have started looking for small parts to paint while I have the gun all loaded up for the bigger stuff.
I found my solid state turn signal box. It was on my truck when I got it with the wires screwed into it, but cut off about 4 inches later. I removed the box and stuck it in my pile of parts. I also recently came into posession of a solid state turn signal switch, (Thanks again Steve) I already had a broken one that came with my spare axle purchase that was broken it had the wiring in the exact same condition as the box. Now that I have both ends along with the wiring plugs for both. I need to figure out if they work and how to wire them up. Does anyone know which pins on each end do what? I know about Star Electric and the wiring loom they offer. I just want to make sure my components work before I go ordering just the wires.
I also while messing with my gauges this weekend discovered something about my 3-lever switch. (I got the truck with the switch installed, but the wires cut off about 3 inches behind the plug. I pulled the switch out, installed a tach in the hole and have lived without it for the last 5 years.) Anyway, it seems that was a replacement switch or something because there is another plug behind the steering column that is hooked to wires that go through the firewall. The fire department ran parallel wires for everything that either broke or they couldn't figure out. Therefore, I have a hug rats nest of wires under my hood. Some stock and some added. None marked. A diagram about what pin does what for the switch would be great. Along with what should happen for each lever moved would really be good.
Thank you.