Need pic and dimensions of PTO linkage arm

[Duane]

can someone send me a pic of the arm that bolts to the PTO, and is connected to the rod that is attached to the handle? I could use some dimensions also. I have been looking for one with no luck.

Thanks

Duane

[fisherman]

I have one somewhere, not sure yet if I want to part with it. I just need to find it so I can get you a picture. I have been working over time and trying to get ready for our FE. Maybe next week I can take some time to look.

[Duane]

ok, thanks, that would help alot

Duane

[brute4c]

I dont have one but I think you mean the arm on the side of the PTO itself shown in ths image as #5:

[Duane]

thats the one, I need the dimensions so i can build one if I cant buy one.

Duane

[brute4c]

Wish I had one to measure for ya...

[sf38a1]

I bought 2 linkage peices at the auto store,They look like the part that screws to the cluch rod. i then got the correct allthread and cut to length,screwed the ends on and bolted in place. I will try to post some pics if I get home early enought sat

[Duane]

actually I have that part, I bought complete handle assy with the rod and ends, I need the arm that is #5 in the pic

Duane

[scuba_dew]

hi Duane,
Here are some pics of the part you seek. I took it off my truck so we could get a good look at it. I will keep it off for a few days if you need anymore measurement. It looks like the end that fits over the splines will be hard to duplicate. Good Luck.













Hope this will help.

[sf38a1]

Have you checked with a parts store. in our area we have a place called Florida Power Train.They can get parts for spicer ,dana,newprocess,etc... since the pto is a chelse, you should be able to get the part thru a shop that deals in power train componts. There are a few places that redo driveshafts that also deal in pto parts,