Bumping for an update from res0wc18.
Printable View
Bumping for an update from res0wc18.
Hello All.
Sorry I forgot to update this. Been a little sideways here as my father passed away.
So I got the donor parts from a fellow member.
I started measuring them up and sketching them in 3D catia.
I have printed off a few clips to see if the strength is going to be of concern.
But progress none the less.
Sent from my SM-G900V using Tapatalk
Res: Ive been lurking on this thread for a while now and happy to hear about the progress . . .and so sorry to hear about your loss.
Bryce
Thanks for your efforts and my condolences on your loss...
Very sorry to hear of your loss.
Like most here looking forward to seeing what you can come up with.
Sorry for your loss.
Bumping for an update from res0wc18. I know you're busy, just want to keep this thread alive.
Gentlemen. I have been our of country, but I have good news and bad news. I finished figuring the air ducts.
Bad news is that with the amount of material I'll need to 3D print them in a blend that will handle the continuous heat it will make these guys cost about $330 bucks a duct (insert shocked face here).
So because of this I am looking at doing some molds for low temp set epoxy.
What does everyone think the real demand is for these?
Sent from my SM-J727V using Tapatalk
Thanks for the effort so far, but as you suspect I'm out at $330 each.
Still interested in a set if you pursue the molded epoxy, and they are within reason.
Again, thanks for your efforts.