Printable View
Where is anyone getting their radial tubes for the taller tires? Gonna put a set of 36" tall tires on and having problems finds the right tubes. The local tire shop had some, but they had the straight stems. I assume I need to stay with the angled stems?
Check this thread: http://www.m715zone.com/vb/showthrea...ht=inner+tubes
The same size tube is good for a tire between 34" (stock NTDs) up to XLs (38-1/2"), so it should work fine for you. And Rusty will know what valve stem you need.
Thanks Tim..................I will check out that thread
If that is International Tube, they don't answer an e-mail (after 3 attempts in 2 weeks) and I can't seem to raise anyone on the phone there either.Quote:
Originally Posted by Binford
I found my tubes and flaps locally.
Hey Private Randy................which valve stems did you use? And I understand I need radial tubes?
I forgot the number but it is followed by a "c" denoting center. I think TR15C, but you may want to verify that. Also check the length. Many truck tubes are 5" and that's a bit long, as they stick out past the rim lip. You can bend them with a tube bender, but be careful if you do, they are soft and can break.Quote:
Originally Posted by dukhunter785
You can go with a radial tube in any tire, but don't use a bias ply tube in a radial. My tubes are radial tubes. Check your flaps too, to be sure they are clean, and rust free. I painted the inside of my rims with POR15 while they were apart to keep them nice and clean and make the install easier.