Does anyone have a picture or a good drawing of the brackets that bolt to the muffler? The maintenance manual has the best drawing I've seen, but it leaves a lot to the imagination.
Thanks all!
Printable View
Does anyone have a picture or a good drawing of the brackets that bolt to the muffler? The maintenance manual has the best drawing I've seen, but it leaves a lot to the imagination.
Thanks all!
I can take a few exhaust photos later today.
I don't know if I have an extra bracket that I can make a tracing of, but I will check.
I couldn't make it to the garage today:confused: , but here are few photos that I had on a SD card to ponder over until tomorrow. I will get that thickness also.
Front view: I fastened the cable with bolts at the muffler. I still have to make the correct pins. Can't find them for sale. I will have to copy one of the originals that was still on the frame mount.
https://i.imgur.com/uy6cTMdl.jpg
Can't see "C" bracket in this rear view of muffler rear flange:confused: it's on the outer side of pipe toward the frame. But same setup.
Crap! I need to dust the inside of the frame rails.
https://i.imgur.com/4TXr5Bul.jpg
Yeah! That's kind of what I thought they should be. From that angle, they don't look thick enough to need a 1 3/4" bolt, but I got 'em, sooo... [emoji846]
I think I saw the pins at the local hardware store. 1/4" x 1/2" (maybe?). I have the 2 pins in the crossmember/hanger to compare to if I can't look up dimensions from the NSN. I'll let you know what I end up with.
Dust the frame?! I'd think there was something wrong if I didn't have dirt, mud or rust falling all over me every five minutes. [emoji16]
Maybe some day! [emoji1]
Thanks!
Pins are 5/16 x 3/4 overall.
Sent from my moto x4 using Tapatalk
View of rear muffler hanger
https://i.imgur.com/eyxH7HWl.jpg
http://i.imgur.com/GZxiC2Yl.jpg
The slotted holes are needed to rotate the bracket around to take the slack out of the hanger cable.
I found a few NOS parts in my stash to photograph.
PM me with your mailing address, and I will mail you a tracing of the "C" bracket.
Oh yea, It's 1/8" thick.
http://i.imgur.com/6oCMm55l.jpg
Ohhhhh, slots! I didn't notice that in the first pictures. Yeah, I'll send you my email in a minute. Thanks for all the help. You've saved the day again!
Can you post a tracing on the site?