Stub shaft angle questions
I'm installing a div. case 205 with gearvendors, problem, the output makes contact with the under the front of the bed through compartment. It's either cut it out or move the t-case down, this creates the angle of my concern. The yoke flanges are set at the same angle. Turning it over by hand theres no bucking or binding of the u-joints. Is this angle going to create vibes or premature wear. Thanks http://img265.imageshack.us/img265/6731/0000166bh4.jpg
pics of added rear tangs for trans mount
Here are some pics of my mod. The piece on the left runs up to that ear, I drilled and taped, and the other side is formed around the other side of the retainer/seal housing to be drilled and taped into the back of the case. My trans was all worn and the holes were all wowed out.
http://img267.imageshack.us/img267/2641/0000174yu8.jpg
http://img267.imageshack.us/img267/660/0000176mm6.jpg