40grit : Brake line ID w/ progress pics

Brake line ID w/ progress pics
Post by 40grit on Jul 8, 2006, 5:39pm

I've finally made some forward progress on my 715...got the frame cleaned up a little, rust converted and rattlecan'd flat black..
I'm starting to run fuel, brake, vent lines...
Can anyone ID these brake lines? I got the full set from Classic tube and had them figured out on the zone, but lost that info with everything else...

this is the front right, with the front left tiewrapped to it, i think..
http://img86.imageshack.us/img86/804...s0015bc.th.jpg

rear brake line, Is this where this goes, why is there some heat resistant sleeve up near the tranny cross member?
http://img204.imageshack.us/img204/7...s0024gt.th.jpg

lines I'm not sure of.
http://img220.imageshack.us/img220/9...ines7ps.th.jpg

Re: Brake line ID w/ progress pics
Post by warwick on Jul 8, 2006, 6:41pm

the front looks right. although my front pass. ran on th inside of the frame all the way around. where yours runs on the out side from the shock tower to front x member drivers side.

the rear looks right aswell. can't say why the heat sheild is there, mine had cloth wrap in that area.

L-R
1]rear axle: hose block over diff to pass. cylinder

2]x-member foward to spliter[end of your second pic forward to spliter]

3]MC to spliter

4]rear axle: hose block to driver cylinder

Re: Brake line ID w/ progress pics
Post by robertcowan on Jul 8, 2006, 9:47pm

WHAT STEERING BOX ARE YOU GOING TO USE AND how are you going to do the pitman arm and drag link ?
BOB

Re: Brake line ID w/ progress pics
Post by jeepistdougiowa on Jul 8, 2006, 10:46pm

Mark, the rear runs through the 2 or 2 1/2 inch hole in the crossmember and tucks inside the frame rail on mine. The front wraps the inside of the frame as suggested above. In your pic you can see the holes for the "one hole" clamps that hold it to the front crossmember.

Re: Brake line ID w/ progress pics
Post by jeepistdougiowa on Jul 8, 2006, 10:50pm

This pic from the manual even notes the clips...#18

http://www.m715zone.com/manuals/20/fig2-76.jpg

Re: Brake line ID w/ progress pics
Post by binfordm715 on Jul 9, 2006, 10:44am

I took some pictures of Fisherman's rolling chassis that clearly shows all the lines. I mean, his chassis shows the lines, but who knows how well my pictures show it!

Oh, and post full-size pics, eh? Quit with the thumbnails! It's an extra step I have to go through and I'm lazy.

Re: Brake line ID w/ progress pics
Post by tacomainoh on Jul 9, 2006, 3:28pm

hmmm I wonder if my frame still has brake lines.

Re: Brake line ID w/ progress pics
Post by binfordm715 on Jul 10, 2006, 12:49am

...And fuel line and breather tube lines to make for very confusing pictures.

Re: Brake line ID w/ progress pics
Post by 40grit on Jul 10, 2006, 8:16am

thanks guys,
bob,
I got the AGR rockram box that I ordered for my 2500hd, but then decided to use in 715..so it's a 2001 2500HD box...with hydraulic ram assist..