Printable View
POR15 VS Sherwinn Williams 2part epoxy primer
Post by elohim1 on Jun 28, 2006, 8:53pm
Truck will be sand blasted tomorrow.
I was going to Por15 the frame. Then Use the Sherwin Williams 2part epoxy primer and carc paint on the body. Everything is disassembled.
Now I am considering just using the 2part primer and Carc green on the Whole truck. Just to make things simpler. The data sheet for the Primer says it has excellent corrosion resistance.
Let me here your thoughts?
Re: POR15 VS Sherwinn Williams 2part epoxy primer
Post by fisherman on Jun 28, 2006, 9:08pm
Sounds fine to me. I will be using Hammerite on my frame. I will be scraping it. Use a crud thug, some hand cleaning with a wire brush. Pressure wash and then maybe brake clean or scrub down with lacquer thinner. Then 2 coats at least of Hammerite. If there is a little surface rust the Hammerite will bond better.
Re: POR15 VS Sherwinn Williams 2part epoxy primer
Post by devildog on Jun 29, 2006, 5:44am
After working with a water cleanup epoxy base grout in kitchens I did some research on water clean up 2 part epoxy primer. Here are the links:
http://www.epoxysystems.com/888.htm
http://corporate.ppg.com/ppg/paf/doc.../aquaponwb.pdf
http://www.benjaminmoore.com/tds/1033/TDSM43M44.pdf
http://www.everestcoatings.com/datasheet....py%20Primer.pdf
This would be an easier and healther epoxy to work with. Hope this helps.