Printable View
Fording kit cable location
Post by lbuck78 on May 1, 2006, 6:23pm
Does anyone Know where the fording plate and cable go on the dash? and if so do you have any pictures? I finally got the motor started and I'm just waiting for the tub to come back so I thought I would work on the dash until then. I'm loosing my shop so I have until the 31st to get it done and ready for the street.
Re: Fording kit cable location
Post by socal715 on May 1, 2006, 6:35pm
33-B9. Valve Control Cables and Dual Valve Control
Using the instruction plate as a template, place it on the instrument panel in location shown in Fig. 33-B7. Locate the center of the large hole 2? in from the left edge of the instrument panel and 4 3/8" up from the lower edge. Center mark the five holes to be drilled. Remove plate and drill four .116? dia. (No. 32 drill) and one 11/16" dia. holes. Then position plate on instrument panel and secure with four (4) 6-18x3/8? self tapping screws.
Position rubber cable grommet in the existing hole of firewall. Insert dual cables through the instrument panel and install cable control washer and nut over cables. Insert cables through grommet in firewall. Position cable control in instrument panel and secure with washer and nut. Position cable conduits in cable clamp of fording ventilation valve bracket and secure with screw. Position cable wires in valve arms as shown in Fig. 33-B6 making sure cable control knob is all the way in and the arm levers are all the way forward. Tighten arm screw to secure the cable wires.
http://www.m715zone.com/manuals/20/ford7.jpg
Re: Fording kit cable location
Post by teking on May 1, 2006, 6:50pm
Sweet!!! OK this is a keeper.
Re: Fording kit cable location
Post by lbuck78 on May 1, 2006, 9:05pm
ok just one more question, what manual is that picture from? I have a copy of tm 9-2320-244=34p and it just shows the parts breakout
Re: Fording kit cable location
Post by socal715 on May 1, 2006, 10:56pm
TM 9-2320-244-20 Organizational Maintenance Manual ?1999